Were to get Extractor(header) flange?

papawfalcon · Post #1 by **papawfalcon** » Sat Jan 05, 2019 7:51 pm

Is there some place in United State to get a flange for Extractor(header). I want to put dual exhaust on my x-flow. Or are they made at all. Thanks Ken.

papawfalcon · Post #2 by **papawfalcon** » Sun Jan 06, 2019 7:00 pm

Ok so maybe if there is a gasket available in USA. i could have one made for the gasket?

hucklburry · Post #3 by **hucklburry** » Wed Feb 27, 2019 6:42 pm

I am just the other side of St. Louis from you, and get over to West Frankfort some to see customers. PM me your #.

I have a template you can trace and measure - I have an extractor for my 76DA block and the gaskets.

I have to go over there soon, so let me know. --Jim

Bikers03 · Post #4 by **Bikers03** » Thu May 23, 2019 3:07 pm

papawfalcon wrote:Is there some place in United paris taxi AirportState to get a flange for Extractor(header). I want to put dual exhaust on my x-flow. Or are they made at all. Thanks Ken.

hi, yes i though that there are more place like this. :shock:

Were to get Extractor(header) flange?

Were to get Extractor(header) flange?

Re: Were to get Extractor(header) flange?

Re: Were to get Extractor(header) flange?

Re: Were to get Extractor(header) flange?

Who is online