Finished porting job

Since the cylinder head was off, I had to do it.

Finally! A porting job I started 4 years ago and never finished. Feels pretty good finally having accomplished it!

www.fungusworks.com/TheShow/html/engine.html

Ctown :checks:

That's a great bit of kit, Ch**y! Just like a Holden head, only bigger in every direction!

Even better to see you haven't polished the insides, like a lot of misgiven head hoggers do.

Sup fella!

I didn't go all the way. There are some small patches on the exhaust ports I didn't clean up only because if I did, I would have to remove more material to make it uniform which I didn't want to do.

I also received the new chip for the ECM/TBI. They leaned it out in the lower RPM's. Can't wait to try it out.

Ctown

Looks great, I can't wait to jump into my Ford I4 head.