I am sure some of the people here have been looking at the Stainless Steel Headers on E-Bay for around $200.
I ordered a set and they look great, the flange mounts up clean to the head, AND THEY ARENT GOING TO WORK.
I have a late 200 six with the low mount starter, the problem is that the rear collector with its three down tubes will not clear the starter and bell housing. They are inboard a good 1 1/2 inches from where they need to be. I tried persuading them with a porta power but they just came back to the original position. The only option I have is to cut and re-weld them. Not very happy at this point as the Vendor has refused to accept them as a return because of his 14 day return policy even though he advertised them as fitting my application.
I ordered a set and they look great, the flange mounts up clean to the head, AND THEY ARENT GOING TO WORK.
I have a late 200 six with the low mount starter, the problem is that the rear collector with its three down tubes will not clear the starter and bell housing. They are inboard a good 1 1/2 inches from where they need to be. I tried persuading them with a porta power but they just came back to the original position. The only option I have is to cut and re-weld them. Not very happy at this point as the Vendor has refused to accept them as a return because of his 14 day return policy even though he advertised them as fitting my application.