I have an early, unserialized CI head. I don’t recall issues specific to the early prod runs, though I know some heads have had pushrod geometry issues depending on the run.
Anyone know something I don’t?
Anyone know something I don’t?
Any issues with early CI heads?
- Thread starter Invectivus
- Start date
Be careful on enlarging the push rod holes, people have hit water in doing so.
I haven't seated it on a block yet, So I have no idea of the alignment ATM. But yeah, that was the post I was thinking of, where they sleeved the pushrod hole. that's a thing I hope I don't run into. I need some work on it, I just want to verify any issues to remediate all at once rather than make several trips to the shop.
Similar threads
