A
Anonymous
Guest
There's some interference between the adapter flange and the throttle shaft on the carb. Grinding will work, but I just wondered if anyone else had this problem before (and for $65, I would have expected it to fit). Plus, the bore on the adapter is slightly smaller than the head inlet. More grinding.
Also looking for some ideas/pics of throttle linkage. Since the Clifford adapter puts the carb sideways, the linkage has to be in the front or back instead of on the side. Do I need a cable setup, or is there something I can do with the stock linkage?
thanks in advance
Mark
Also looking for some ideas/pics of throttle linkage. Since the Clifford adapter puts the carb sideways, the linkage has to be in the front or back instead of on the side. Do I need a cable setup, or is there something I can do with the stock linkage?
thanks in advance
Mark