Attatching port divider to head(exhaust)

[Anonymous]

The welds holding in my port divider have broken off and I need to re attach it. I didn't put it in in the firts place, so I don't know the right way to do it. Will a regular line feed welder be sufficient, or is there something else that I need to do. This is just and idea, but, what about JB Weld?
PS: Engine is complete in the car, with headers removed as well as air cleaner for work room.

 

[66200i6]

There has been a lot of discussion on the subject. I'm sure you do a search you will find something.

I think the JB Weld has been used but don’t recall if it lasted. I believe the feed for welding needs to have nickel content. Mine is an interference fit but I haven’t actually run it yet.

Good luck, Ric.