H/W 5200 Bolt Hole Spacing

[Williboy]

Does anyone know what the exact bolt hole spacing measurement in .000" for a 5200????
Actually I only need the narrow side.

I can't get to my carb for a few days and I'm measuring off of a gasket.
I'm getting 1.824"

I'm working on a cable throttle bracket design, that I'll be posting about later. ( Also a easy kickdown too)

Thanks,,,GLEN

 

[xctasy]

46mm by 93.5mm. (1.811" x 3.681").

Holes are supposed to be 32/36mm, but Holley says 1.28" by 1.4375", which is 32.5 by 36.5 mm.

The stock carb can be gas flowed to yield up to 17% more air flow, which improves the hp level it can run at by up to 20 hp. Venturis can be taken out to 30 and 31 mm, up from the 26 /27 mm stckers these things ran. The extra 157 thou sometimes breaks through the casing on carbs with core shift, so just add some JB Weld Epoxy and smooth off. My friend has one on his Capri 3000 V6. It's a good carb.

 

[Williboy]

Thanks, that's the measurements I was looking for. ( 1.811")
I realized later that it was probably metric.
What's 0.013 among friends!!!!!!