I am starting a turbo 200 build in the near future (actually it's already on the engine stand) and I am very impressed with Does10's 63 and a lot of the fellow inliners rides here on the forums but I can't find any information on what aftermarket parts that you guys have used for the bottom ends of your sixes. I know that I need to beef up the stock rotating assembly before I throw some decent boost at it but off the shelf aftermarket parts just aren't readily available for items such as forged or billet rods, etc. Any recommendations on where I could find those type of parts? I'm going to get the full rebuild kit from Classic Inlines w/ forged pistons but it sure would be nice to amp up the rods to hold them. I've seen some of Does10's pics and throwing a rod would just make me sick after spending the time and money to build the engine right. Any other tips for strengthening the short block would be helpful as well. I'm looking to get at least 300hp out of her. Thanks!