hucklburry
Well-known member
So I have a 76DA Block and later aluminum headed 250, and I am trying to find a flywheel, which is sort of a PITA, if I am right that I should be looking for a 10" clutch to fit inside this manual bell housing.
Will a 10.4" clutch fit in the bell? That would make the flywheel easier to get - my real problem is the people selling the flywheel not answering the question if a 10" will fit the flywheel. I think they both have the same bolt pattern, but I am not sure.
I am looking for a reasonably priced flywheel, I've found plenty for $300-$400, but if I can answer this question about the clutch, or the people selling the flywheels confirm a 10" clutch will fit, I can get one for much less.
Thank you --Jim
Will a 10.4" clutch fit in the bell? That would make the flywheel easier to get - my real problem is the people selling the flywheel not answering the question if a 10" will fit the flywheel. I think they both have the same bolt pattern, but I am not sure.
I am looking for a reasonably priced flywheel, I've found plenty for $300-$400, but if I can answer this question about the clutch, or the people selling the flywheels confirm a 10" clutch will fit, I can get one for much less.
Thank you --Jim