challenger6
New member
Well, Since everyone here so far has been so helpful , I thought that I would start a thread to keep up with my engine/car build. Any positive or negative criticism is welcome. After ordering my dished JE pistons and timing set from Mike, I disassembled a 1965 and a 1981 200 engine. I then started working on the forged C3 connection rods. I spent a couple of hours working on the beams of the rods. After I used three steps to remove the casting lines, I then ran them in a shot-peen machine to get them to this point. They are now headed to my shop to start prepping them for Micro-slick, then they will be getting a new set of ARP bolts. The pics are after they came out of the shot-peen. I will post pics after they are coated too. More to come________Lee