Colonel Flashman
Well-known member
Some time back I swapped a 170c.i. head onto a 200c.i. block & had great performence & luck w/ it.
What is the Possibilty of doing the same thing w/ a 215 c.i. Head onto a 223 c.i. Block?
Will everything inside (in & outlets,etc) & outside (bolt holes, etc.) Mate Up?
I did this originally on the 200 c.i. block to avoid milling the 170 c.i. head. I got just as much of a jump on the Compression Ratio doing this as I would have if I had milled the 200 c.i. head.
This is why I would like to know, I prefer avoiding Extra expences if I am able.
Thank'ee
What is the Possibilty of doing the same thing w/ a 215 c.i. Head onto a 223 c.i. Block?
Will everything inside (in & outlets,etc) & outside (bolt holes, etc.) Mate Up?
I did this originally on the 200 c.i. block to avoid milling the 170 c.i. head. I got just as much of a jump on the Compression Ratio doing this as I would have if I had milled the 200 c.i. head.
This is why I would like to know, I prefer avoiding Extra expences if I am able.
Thank'ee