The oil drain must be at the bottom, or at most 15 - 20 degrees off vertical.
Ahhhhh......getting the turbine housing free! Not easy. Forget WD-40.
For this you will need a rosebud torch tip and get the housing uniformly very hot (near cherry red will help) and pound it off with a hammer.
Also make sure it flows as freely as possible very inportant or it WILL smoke out the tail pipe the ID of the drain needs to be large even 1 psi of pressure in the center cartridge will make it blow smoke, gravity is your friend. :wrench:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
