67Straightsix
Well-known member
I have my intake and headers mocked up on the engine. I'm going a little different direction than most people on the forum, so I'm posting some pictures
of the build so far.
https://imageshack.com/i/pa6TIawvj
https://imageshack.com/i/p311VtSBj
https://imageshack.com/i/p3Ogt7PCj
The head has been ported - I'm using 1.46 ex. and 1.75 int. - have forged pistons and a.r.p. bolts
I'm using Holley HP for my fuel and ignition management and Ford throttlebody
of the build so far.
https://imageshack.com/i/pa6TIawvj
https://imageshack.com/i/p311VtSBj
https://imageshack.com/i/p3Ogt7PCj
The head has been ported - I'm using 1.46 ex. and 1.75 int. - have forged pistons and a.r.p. bolts
I'm using Holley HP for my fuel and ignition management and Ford throttlebody