170 nitrous??

[Anonymous]

i´m planning to put a 200 head, 3 angle valve job, ported and polished, compression around 9.5:1, a holley 2bbl (2300), tube headers, sinterized clutch and a "homemade" nitrous system (http://www.diy-nitrous.fsnet.co.uk/) to run with the original pistons. 25 or 40 hp shot.

with this mods, can i get into the 17.80 or 18s?? in 1/4 mile.

i dont want to put a cam right now or work with the alternate mass.

I wait for suggestions

bye!

 

[trashline]

remember that crank has only four main bearings. the carb upgrade is a good idea. just make sure the carb is rich bc if you go lean for some reason say goodbye little 170 pistons. i also wouldnt go more then 40hp time wise that motor was probably like 20s in the 1/4 so id say maybe around 17s