All Small Six 200 'extreme duty' Rods and Rockers?

[powerband]

I'm looking for info on alternate/aftermarket connecting rods used for the Ford 200 small block for a high RPM vintage road racer engine.
... also successful aftermarket rocker arm setups used on the aftermarket Aluminum (VI) head.

thanks

“Do not correct a fool, or he will hate you; correct a wise man and he will appreciate you.”


. .

 

[pmuller9]

200ci - Alternative 200 six connecting rod

We had a joint effort looking for an aftermarket rod for the 200 and drag-200stang found that the Toyota 1JZ rod would be a good candidate. 4.931" center to center 2.166" BE bore for the 2.047" crank pin 1.020" BE Width 1.00 PE width. 22mm pin Comes in sets of six.

fordsix.com

https://www.dropbox.com/s/08j7cjqpzj7gcb8/inline 6 rods resized.jpg?raw=1
https://www.dropbox.com/s/bss7uc6xo6ooycn/rod resized.jpg?raw=1
https://www.dropbox.com/s/mz03eha6z2erxht/6 rods resized.jpg?raw=1

 

[bubba22349]

Hi powerband, On Rockers Arms there are two choices in for a heavy duty use that I know of both are 1.65 ratio Roller Rocker Arms. Rocker Arms Unlimited (RAU) is now also making a set of Aluminum Roller Rocker Arms these would use the stock type lifters and push rods to view them see the following attachment. View attachment 4510 RAU http://rockerarms.com

And then there's the well known Yella Terra Aluminum Roller Rocker Arms too, these use the FE Lifters and oil through push rods, you will also need to plug off the rocker arm oil feed in the block deck. https://www.vintageinlines.com/product-page/yella-terra-adjustable-1-65-full-roller-rocker-set