All Small Six AUSSIE HEAD

[48 F3 Joe]

There is a Aussie head and engine on Spokane Craigslist located near Kettle Falls if anyones interested. Type in 1966 and scroll down. I live close by and could take a quick look.

Joe

 

[78_200_C4]

1966 Ford 200 6 cylinder engine with 2V Aussie cylinder head.

Ford 200 6cyl w/ Aussie 2V head - auto parts - by owner - vehicle...

1966 Ford 200 6 cylinder engine with 2V Aussie cylinder head. 7 main bearing engine with very low miles, about 7,000. Short block was built by Brent Faulkner, Hatch Engine Inc., Aumsville, Or. for a...

spokane.craigslist.org

 

[1981 Capri]

Interesting , thanks for posting this . i have the 200 log head , would be nice to have that 2V head . what do the 2V heads sell for ? how hard are they to find ? is that a big bell engine ? low mount starter ?

 

[bubba22349]

It's a 1966 200 Six Block Duel Bell Housing Bolt Pattern all of those small Six's are High Mount Starters. The Low Mount Starter Big Bell Housing Blocks were only made the Last year to Year and a half. However the Aussie Heads will fit on any year of the 200 or 250 Small Six Blocks, also of note is that the C. I. / V. I. Aluminum Heads are an up dated version of those Aussie 2V Heads.

 

[anotherhassel]

Interesting , thanks for posting this . i have the 200 log head , would be nice to have that 2V head . what do the 2V heads sell for ? how hard are they to find ? is that a big bell engine ? low mount starter ?

I can tell you that mine shipped from Oz wasn’t cheap. But 100% worth it!

 

[1981 Capri]

100 % worth it ! if i was much younger and did my own work i would like to have that 2V head . so i look at pictures of what could be and dream on . i need to keep it simple and not create another hassle .
interesting this engine with a 2V head was changed out for a 302 V8 , in my area if i sold my car that's what would happen to it .

 

[Jmustang_65]

Interesting , thanks for posting this . i have the 200 log head , would be nice to have that 2V head . what do the 2V heads sell for ? how hard are they to find ? is that a big bell engine ? low mount starter ?

Shipping alone from Oz is about $700-800 dollars. So the head can be sold for about $2000.

 

[Cox Custom Mechanical]

You could use a crossflow head

 

[Jmustang_65]

You could use a crossflow head

Your willing to ship some to the USA

 

[rocklord]

Your willing to ship some to the USA

Read this article to see what is required to install an OZ Crossflow head to a US 200/250.

Classic Inlines - 250 Cross Flow head swap

 

[Jmustang_65]

Read this article to see what is required to install an OZ Crossflow head to a US 200/250.

Classic Inlines - 250 Cross Flow head swap

Too much work.