carb

  • Thread starter Thread starter Anonymous
  • Start date Start date
A

Anonymous

Guest
what kind of efficiency can I expect with a 5200 holley carb from stovemolt compared to a autolite 1101 carb????

Must I put that carb in with headers or can I put the carb on first then wait a few months for money to come in then buy the headers??
 
Remember, efficiency in theory will not change much with a larger carb. What happens in actuality is that you start to enjoy the new power more and become more lead footed.

IE: Pre-aussie running an 1100, I got 28 MPG on the highway. Added the 390 4V, my mileage is like 20MPG, mostly because I enjoy my lead foot more. If I milk my mileage and drive like I had the 1V on, I can get 26 MPG.

Obviously, I larger carb will decrease some just due to dropping more fuel usually a little, but it won't make a huge difference if you stay off the throttle.

Slade
 
Isn't the 5200 a little newer, better designed than the Autolite 1100? I have been figuring that the newer design would give me a better mixture and therefore more efficiency, is this wrong? I have seen Pony Carbs advertising their rebuilt 1100's where they say they have 'fixed some of the original issues with the 1100 carb.'

I am not looking for power so much as economy, wouldn't a carb and distributor trade help this out?

-Dan in Atlanta
 
Howdy All:

Havoline- The carb can be used by itself. It won't give you much more in the way of performance over a 1101.

The H/W 2 stage two barrel is a more sophisticated carb than an Autolite 1100/01. THe primary bore is smaller than the 1100/01. The secondary butterfly doesn't begin opening til about half throttle. It will require some fine tuning to get it right on a Ford Six. If better mileage, driveability and smoother idle are the goal then to that extent, it will likely be "more efficient".

The term "Efficient" may be confusing in this discussion. Relating to "VE" or volumetric efficiency, slade is right. Changing to a larger carb may not change the VE, as it has many factors that effect it. VE is typically calculated at WOT in an rpm range near the peak torque reading. Obviously, this will take into effect cam timing, head flow, compression ratio, exhaust, ignition and, of course intake. Simply changing to a larger carb will not have much effect on VE.

Dan- Yes, for economy the two stage 2 barrel design should be better for economy. The smaller venturi should create higher vacuum and more velocity, creating a better mixture. A well tuned 5200 might give you a 10% increase in cruise mileage under ideal conditions. So if you're getting 20 mpg, you might see 22 mpg. This is assuming an optimized ignition system too.

realistically, you should be able to get that much of an increase in mileage by optimizing all the systems that you presently have, and follow Slades advice and drive as if your go pedal foot was a raw egg and if it breaks you have to clean up the mess.

Adios, David
 
I think people bash the 1100, it's just misunderstood. I never had any issues with any of my 1100s (and I even had a pony carb version). They are IMHO too small for a mild 200, but otherwise is a good carb. My engine with nothing but a cam upgrade made it very obvious the carb was limiting my car.

Slade
 
Back
Top