Hooking up linkage for a Holley/Autolite 2100 2BBL Need Help

[Anonymous]

: [/b]Hey everyone!! I'm new to the site and hope someone can help. I'm currently setting up my Sprint 200 with a Holley rebuilt Autolite 2100 2BBL carb with the clifford adapter. My mechanic and I have ran into a question about the linkage. has anyone ever modified the linkage on the 200 for the carb or went to a different cable set-up altogether. I really would like to keep my orginal set-up on the linkage with just a few modifications to it. If anyone knows or has done this type of mod please LMK. any help would be appreciated(pics would be great also)...thanks

 

[CobraSix]

mrgasket.com or lokar cable has stuff that can modify your current linkage. That's what I'm using.

Here is the mrgasket catalog:

http://www.kastang.net/reference/CarbFuelAcc.pdf

Almost every autozone, napa, advance, etc has the Mr. gasket catalog that you can order stuff from.

Slade

 

[Anonymous]

Theres 3 ways you can do it,

1.) Use the Lokar cables like Slade said.
2.) Use a 92 Ford F-150 fuel injected 300 6 throttle cable & a 86 (or equivalant) Mustang gas pedal. Fairmont, granada, F-150, etc gas pedal should also work.
3.) Extend the stock rod like I did shown below,

The stock rod is extended with some electrical conduit and the return spring kit is a summit holley return spring kit. You can also order the little heim joints for the linkage from summit also.

I've used both setups and the cable linkage is a lot better IMO!!

Later,

Doug

 

[Anonymous]

Thanks alot guys. I believe we can do it with this information...

 

[Anonymous]

Hey Guys, just wanted everyone to know I took you guys advice and hooked up the linkage. It works great!! I recently showed my 'stang at the Hunter's Auto Expo in Nashville, TN. Here are a couple pics of my beloved '66. Check out the set-up and LMK what you think...thanks again for the help :!: :!:

 

[Anonymous]

Here's a little bit bigger pic of the linkage..later :!: :!: 8)