rear axle help !!!!!!

[Anonymous]

after adding the brackets to the rear axle and did wanted to tidem them up , i cant tidem them any further ?????

they wont go any further into ore onto the axle ? is this wright ? wat i,m doing wrong ? it looks like after i did remove them , there was a gasket between them , so they must come togheter , but now they wont go any further ? i dont get it , before i do some hammering ore havy work for getting them right in , would be good to post first a topic here, bevore i,m going to damage something !
give me some tips !! wat is wrong with my setup ?

 

[Anonymous]

Either you did not line them up and push them into the rear pinion all the way, You can to fiddle a little till the splines line up then it slips right in. Or you reversed the axles and placed the long in the short side. The long axle is on the Right Side (Passenger Side) and the short one goes into the LEft side (Driver Side)



Kelly
San Antonio

 

[MustangSix]

The bearings will not go all the way into the housing. Remember, there was a backing plate and a gasket before.

But this isn't a problem. Just install the plate and tighten it down. It will still hold the bearing in place.