If the temp sending unit is a one wire,don`t use tape or sealer on the threads.The unit grounds through the sender body,and the tape or sealer will interfere with the ground.Result will be errors in the readings on the dash gauge.OR,no readings at all.
Good luck.Have fun.Be safe.
Leo
If the temp sender is leaking then it would also be coolant or water not oil, you can use some Permatex or silicon to seal the threads. You might also look a bit higher up at the valve cover gasket being your real oil leak. Good luck
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.