Where can I get instructions for hooker headers?

[Anonymous]

I checked holley.com but had no luck. Does anyone have the instructions, and could you make copies for me? Or is there a website where I could find them? Thanks

 

[pedal2themetal45]

HI
I don't think there is instruction for headers :
What is it you need to know?
applacation?
Fitment?
Mostly you just bolt them on?? for the ford 6 there may be a divider the goes in the head between 3 & 4 cause those two do shair a head port and that would divided them for a header and better flow out..

Tim

 

[Anonymous]

i miss read this....left out "headers"

I was like "huh?"

 

[Anonymous]

Hah!

 

[AzCoupe]

Is this what you were looking for?

Once you have all the bolts started, lightly snug them up. Starting from the center, work outward in a crisscross pattern. Then go back and torque the bolts in the same manor to 30-35 lbs. Never over tighten.

I torque to 20-25, then go back over again, to 30-35. I also spray the bolts with WD40 before installing them.

Start the motor and run till it reaches its normal operating temp, then shut down. Once its cooled down, re-torque the bolts once more. If your using the Breslin bolts, don't tighten the set screw until this step is competed.

Go back and re-torque the bolts once more after a few days have passed (or cycles running up to operating temp and cool down).

 

[Anonymous]

Go back and re-torque the bolts every few days

 

[Anonymous]

I don't really need them for installation, but would just like to have them. Thanks!