I have a offenhauser 3 carb intake for my '68 mustang. the cylinder head is actually off a '70's engine (I think 77, i'll have to go look). I was trying to install the linkages this morning and couldn't figure it out from the instuctions that came with it. Does anyone know where i can find better instructions? Or could someone send me some good pics so i can see how its done?
Offenhouser assembly help!
- Thread starter JoeJoe44
- Start date
I don't know if these photos will help. It's a large PDF file and the adapter you're using is on page 25
http://www.exeterautosupply.com/Docs/Of ... atalog.pdf
http://www.exeterautosupply.com/Docs/Of ... atalog.pdf
kevinl1058
Well-known member
That is were I purchased my kit from. came complete. I will tell you that instructions aren't the greatest. and also the manifold is not a simple bolt on you will need a machinest to fit the intake properly.
kevin
kevin
here is a pic of my setup.
[img]http://i305.photobucket.com/albums/nn214/falconsix/211001-1.jpg[/img]
[img]http://i305.photobucket.com/albums/nn214/falconsix/211001-1.jpg[/img]
Similar threads
