piston help

[Anonymous]

forged piston set for a 200ci [ D8 code ]
new . ore otherwhise , where can i order them ?
here in holland they look verry stupid to me when i,m asking for pistons for my 6l
you drive a 66 mustang with a 6l?
YESSSSSSSSSSS i do !!!! with pleasure !!!!!!!!!
thats why i dont give up my 6l.aspecialy when i did open up my hood !

had already many offers with V8 complete engine,s but i stick to my 6l !

is there a complete overhaul set to buy for a 200ci?
how about the pistons from the 2,3 SVO ?
keep in mind that i,m gone do a turbo setup ,so i want the best for my rebuild !
any other suggestions are welkom for a highperformance rebuild !
i already into it with AZ for sending a 250 2 V head with 3 angel valve job and stainles steel valve,s [ the bigg 1,s ]
so only needing advise for the block .

 

[addo]

What about ACL hypereutectic cast pistons? Less cold startup "slap" than a forged unit and fine for mild turbocharging. "AlloyDave" can tell you all about the different models available.

Adam.

 

[xctasy]

And that they are based on Eurpoean Mahle castings.

475 hp in a turbo 3.3 Holden with these type. At 93.5mm, they may even be based on BMW M1 or M5 635 Csi pistons. Wrist pins are bigger, but the bore is very close in size. 1985 BMW 325 M3's ran similar sizes.

 

[x21]

Wow, that poor #6 spark plug wire, stretchin it! hehe. Nice lookin engine though. 8)

 

[Anonymous]

#6 spark plug wire
i now , did order a orginal 6l setup , this is what i did get !
did told them that i got a dura spark set with a bigger diameter cap !
would be np they said ! wel ,here is the resuld , did order 1 new cable for the nr 6 !
btw,, who is selling a complete engine rebuild set !
always the V8 and 4 cyl are offerd , did they forged that ford did make 6 cyl inline ?