Cam for my new engine.

[Anonymous]

I have thought about it untill my head hurts! I don't know what cam will be the best. Everything I THOUGHT I knew about a good "turbo cam" got killed after I saw how the Clifford 280 (on 108 lca) ran with the turbo. I would put it back in there if it was not broke. So I am thinking about one of FSPPs 280s but I don't know if a smaller one would work better. What do you guys think?

Dan

 

[66Sprint6]

Hey man,
Heres what Mike came up with for my build...

"The cam is from Clay Smith. It's the same grind Does10 is using in his.

274 dur - 224 dur @50 - 480 lift - 112* lobe center."

Hope that helps
Matt

 

[Anonymous]

This is the one I will be using in my turbo 200, "version 2.0" from Ford Six perf parts.

Product ID: CSC-274-12-SHS
CSC-274 (112*) Hydraulic Single Pattern Camshaft

Adv dur - 274/274 Dur @.050 - 224/224 Lift -.450/.450 Lobe center - 112*

I will be copying many of the engine build details of Teppo's (80stang) engine (Gen 2)

http://www.ponikorjaamo.com/ti80/gen2.htm

Here is how his engine sounds with the 224* cam:

http://www.ponikorjaamo.com/ti80/Jru9_sounds.wav

I like it!
It should work well with the turbo, also. I thought it was too big for a 200, but he says it runs well with no loss of low end torque.