Need help re-installing the harmonic balancer/damper on a 1966 Ford 200 ci block. Do I need to get a harmonic balancer tool to do so? What are some tips and tricks to installing this part?
Yes the Dampner tool is the best and safest way to do the install. However if you could find a bolt long enough and has enough threads or some all thread (in the corect fine threads) togeather with a nut and a thick flat washer you could use that to pull the dampner on. Make sure everthing is clean inside Dampner hub, and crankshaft end, no burs on the key or key way, is free of any dirt / grime or surface rust. Put some engine oil or light grease (white lithium) on the Dampner hub were it contacts the seal lip and also the timing cover seals lip. Best of luck
Should be nothing special to installing the 'balancer'/Pulley with key unless crank snout is scratched or pitted. Can be sanded clean with Emery cloth. Torque spec is considerable at 85-95 ft lbs and clamping FW or other practical method while tightening retainer is recommended. "Back in the day' some would put some rope down the plug hole to 'seize' piston/crank but not sure it's a recommended procedure.
I've not needed to install but tool is recommended procedure. Gentle raps on center with a non-metallic hammer or 2X4 may help it along. If stubborn I would be sure crank is cool/cold and balancer is a lot warmer to encourage it.
Care needs to be taken installing/seating the seal in front cover and a little lube on seal or balancer seal land helps prevent catching seal lip when installing. If re-using the balancer/pulley inspect the seal land for wear. A solution to any wear is to install a 'Speedy Seal" stainless sleeve with some loctite type stuff.
RockAuto ships auto parts and body parts from over 300 manufacturers to customers' doors worldwide, all at warehouse prices. Easy to use parts catalog.
www.rockauto.com
Isn't inline Ford small block internally balanced and not needing a true 'balancer' but a vibe' dampener ?
"dampener". Do not damage rubber 'inner webs' bonding the sleave next to crank to outter (surface for belts) edge of it. The 200/3.3 hasa -0- balance FW and very long crank so the dampener needs 2B a great harmonic balancer. powerband's in above pic isa performance component that offers more than the oe. Onea rebuild or for'n upgrade a new dampener should be used. Some do not but check that rubber very well~
Put a dab of RTV on the keyway to prevent an oil leak.
NEVER install a damper with a hammer. It might cause the rubber outer ring to loose its bond.
Always use a tool or bolt with washer to install & torque as mentioned.
The crankshaft bolt and thick washer holding the Dampner on the front of the crankshaft snout is torqued to 85 to 95 Ft. LB's. The Dampner tightens up against the crankshaft timing gear which backs up to the crankshafts face of the front main bearing journal the spacing is automaticly set if you have all the correct parts installed in their proper order. Best of luck
If it starts going on stupid hard, make sure that the key has not moved back ...If it moves back it will ride up a ramp acting like a wedge, not good...Make sure when you start that the key is flatly in place.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.